5W 8Ω Miniature Loudspeaker for Arduino, JST Interface.

CQRobot has carefully configured this passive miniature loudspeaker for makers and electronics enthusiasts, Compared with the previous generation, the volume level has been greatly improved. This miniature loudspeaker uses JST-PH 2.0 mm 2-Pin interface, resistance 8 ohms, power 5 watts, long strip size, with mounting screw holes, suitable for all kinds of small DIY electronic projects, the sound is clear and pleasant without distortion.

Wiki: http://www.cqrobot.wiki/index.php/Miniature_Loudspeaker_3_Watt_and_5_Watt_SKU:_CQRLS-A

SPECIFICATIONS

• Impedance: 8 Ohm Plus/Minus 15% at 1000Hz.1V;
• Power Rating: Rated Power / Maximum Power 5.0W / 5.5W;
• FO: 450Hz Plus/Minus 150Hz at 1.0V;
• S.P.L: 94dB Plus/Minus 3dB/1.0 Watt 0.1Meter; Average At1000, 1200, 1500, 2000Hz;
• Frequency Range: FO to 10,000Hz. Average SPL-10dB;
• Distortion: 10% Maximum at 1000Hz.1.0V.
• Abnormal Sound Test: Must be Normal Tested by 6.32, Volts.Sine wave for 50 to 5KHZ;
• Polarity: Diaphragm Shall Move Forward When Apply a Positive DC, Red "+" or "Marked" Terminal;
• Operating Temperature: -25 Degree Celsius to +65 Degree Celsius;
• Storage Temperature: -25 Degree Celsius to +65 Degree Celsius;
• High Temperature Storage Test: 65 Degree Celsius Plus/Minus 2 Degree Celsius - 96 Hours;
• Low Temperature Storage Test: -25 Degree Celsius Plus/Minus 2 Degree Celsius - 96 Hours;
• Size: 70mm * 31mm * 16mm.
• Screw hole distance: 24mm * 63mm;
• Interface cable length: 40cm;
• Total weight: 24g.

SHIPPING LIST

2 * JST-PH 2.0 mm 2-Pin interface 8 ohm 5 watt miniature loudspeaker